HoMedics BPW-260 Blood Pressure Monitor User Manual


 
1413
Replace the batteries if:
1. The weak battery symbol appears on the display.
2. Nothing appears on the display when the power is
switched on.
As the supplied batteries are for test only, they may
be discharged earlier than batteries you buy in stores.
Replace all batteries at one time (as simultaneous set).
Use only 1.5V AAA alkaline batteries. Remove batteries
when unit is not in use for extended periods of time.
Date and time will need to be reset if batteries are
removed or replaced. Clean contacts on battery and
in battery compartment with a soft dry cloth each time
you install batteries.
INSTALLING BATTERIES
1. The battery cover is located
along the bottom side of the
monitor. Remove battery cover
by pressing down and pulling
away from the monitor.
2. Install batteries according to
the polarity indications inside
the compartment (as shown
in figure 2). Battery Type: 2
Alkaline LR03 (AAA) size
3. Insert the other battery,
according to the polarity
indications inside the
compartment (as shown in
figure 3).
4. Replace the cover by inserting
it back into place.
Note: Batteries are hazardous waste. Do not
dispose of them together with the household
garbage.
1.
3.
4.
2.
BPW-260_A.indd 13-14BPW-260_A.indd 13-14 12/7/09 4:48 PM12/7/09 4:48 PM