HoMedics BPA-201 Blood Pressure Monitor User Manual


  Open as PDF
of 33
 
11 12
INSTALLING BATTERIES
1.Extend the tray so that the battery cover is fully exposed.
2. Press down on latch and lift the battery cover to open the
battery compartment.
3. Installorreplace4“AA”sizedbatteriesinthebattery
compartment according to the indications inside the
compartment.
4.Close the battery cover by pushing in the top end of the
battery door.
Replace the batteries if:
1.Theweakbatterysymbolappearsonthedisplay.
2. Nothing appears on the display when the power is
switched on.
As the supplied batteries are for test only, they may be
discharged earlier than batteries you buy in stores. Replace all
batteriesatonetime(assimultaneousset).Useonly1.5VAA
alkaline batteries. Remove batteries when unit is not in use for
extended periods of time. Date and time will need to be reset
if batteries are removed or replaced. Clean contacts on battery
and in battery compartment with a soft dry cloth each time you
install batteries.
Note: Batteries are hazardous waste. Do not dispose of them
together with the household garbage.
USING THE AC ADAPTER
Note:
•PleaseunloadthebatterieswhenoperatingwithanAC
adapter for an extended period of time. Leaving the
batteries in the compartment for a long time may cause
leakage, which may lead to damage to the unit.
•No batteries are needed when operating with an AC
adapter.
•Date and time will need to be reset if AC adapter is
unplugged and unit is without batteries.
1.Connect the AC adapter with the AC adapter jack in the
back of the unit as shown below.
2. Please use only the AC adapter included with this monitor.
Battery
Cover
Slide-Out
Tray
AC Adapter
Input:100-240V~0.2A50/60Hz
Output:6VDC1A6WMax
Connect
AC Adapter
here
 previous next