HoMedics BPA-201 Blood Pressure Monitor User Manual


  Open as PDF
of 33
 
19 20
Pulse
Pulse
Pulse
1.PresstheUser Select ButtontochooseUser1
or User 2.
2. With the cuff wrapped around your arm, press the START/
STOP button. Do not inflate the cuff unless it is wrapped
around your arm. All digits will light up to check the display
functions. The checking procedure will be completed after
about 3 seconds.
3. After all symbols disappear, the display will show
“00”.Themonitoris“Ready to Measure” and will
automatically inflate the cuff to start measurement.
4. Thecuffwillbegindeflatingasmeasurementcontinues.
Note: This monitor will re-inflate automatically if the
system detects that your body requires more pressure for
measurement.
5. Whenthemeasurementiscompleted,
the cuff will deflate entirely. Systolic
pressure, diastolic pressure and pulse
will be shown simultaneously on the
LCD screen. The measurement is then
automatically stored into memory.
Note:
1.Thismonitorautomaticallyturnsoffapproximately1 minute
after last operation. You may also press the START/STOP
button to turn the unit off.
2. To interrupt the measurement, you may press the
START/STOP (recommended), “M,” User-Select
or Date & Time Set ( ) buttons. The cuff will deflate
immediately after a buttons is pressed.
Pulse
Pulse
Pulse
Pulse
Pulse
PulsePulse
Pulse Pulse
Pulse
Pulse
Pulse Pulse
PulsePulse
/
START
STOP
OR
/
START
STOP
 previous next