Hitachi rm-ltx7000 Electric Shaver User Manual


 
Safety precautions
1. Never use cream or gel shaving agents.
Cause of clogging and damage to the blade.
2. Never soak the blade in water.
Cause of damage to the shaver.
3. Never dry it using a dryer or a fan heater, etc.
Cause of deformation or damage to the shaver.
4. Do not charge at each time of use.
Cause of impairment of the battery performance
5. Do not dry any other body than this shaver with the LED light dryer.
Cause of failures
6. Do not place the LED light dryer in a tilted or unstable position, and do not move it during use.
Cause of failure of the equipment
7. Never allow to dry or leave it in a place exposed to direct sunlight and high temperatures.
Cause of damage to the shaver due to deformation and deterioration of the waterproof rubber.
8. Never wipe the shaver or the power adaptor with alcohol, benzene, and thinner, etc.
Cause of deformation and discoloration.
If the blade surfaces are applied to the skin too strongly as the battery level is low or maintenance is
inadequate, an automatic stop may be made by the protection circuit functioning under an increased
load. The shaver can be used by connecting the power adaptor and turning "ON" the switch again.
Charge as it is or carry out a sufficient level of maintenance.
(If the shaver does not move even when the switch is turned “ON,” connect the power adaptor to the
main body, insert the power plug into an outlet, and then turn “ON” the switch again.)
Name and function of each portion (Fig.1)
Cap Protects the blade.
Head holder
Foil-cutter assembly
Foil, cutter, center trimmer,
and cleaning washer are assembled.
Foil
Cutter (Drum razor blade)
(incorporated in the cutter)
The cutter cannot be disconnected
from the foil-cutter assembly.
Cleaning washer
Changes the flow to wash the cutter and
foil for maintenance.
Selector button
Selects between auto mode,
power mode, and normal mode.
Battery (Built in)
Lithium ion battery 1 pc.
Main body socket
Foil-cutter assembly detaching
knob
By sliding this button sideways, the
foil-cutter assembly can be detached.
Head holder removal button
Never press this button during operation.
Never use any other power adaptor and LED light dryer than the ones included.
Also, do not charge any other product with the included power adaptor.
(Cause of fires by short circuits or abnormal heating)
Do not remove the main body from the LED light dryer during drying.
(Cause of burns by the light emitting lens or foil that becomes hot during drying)
Do not apply the trimming blade directly to ears and nose.
(Cause of injury to ears and nose)
Disconnect the power plug from the outlet when it is not used.
(Cause of injury, burns, or electric shocks and fires from electric leakage due to
insulation degradation)
Prohibited
Unplug
Switch
If this switch is pressed, the shaver is
turned "ON" and if this is pressed again,
the shaver is turned "OFF".