Filter
Top Products
Description of Display Marks
Display mark Condition/Cause
I
Low Battery
l Mark appears when
the battery voltage is
too low for the monitor
to work properly
Corrective Action
Measurement is in progress-
remain as still as oossible
Replace all lour of the batteries
with new ones
Memory OperationMemory Operation
1. When a valid measurement is made, the
reac
1. When a valid measurement is made, the
reac
pulse rate) will be stored in the MEMORY aspulse rate) will be stored in the MEMORY as
Try the measurement again. Remain
very still during the measurement
IinQ
data (systolic, diastolic, and
soon as the unit is turned off.
2. The reading in MEMORY can be viewed at any time (except when another
measurement is in progress) by pressing the MEMORY button. An “M” appears
in the lower left corner of the display when you are viewing the data in MEMORY.
3. After another valid measurement is performed, the results of this current
’
measurement will appear on the display. When the MEMORY button is
pressed, the previous reading will appear once on the display ( along with
the “M” symbol), then the display will revert to the current reading.
4. When the unit is shut off (either by manually pressing the ON/OFF button or
when the Auto-off feature operates) the last valid reading taken will be stored
in MEMORY, over-writting the previous data.
NOTE: Memory data will be lost if batteries become low or are removed.
Caution
1.
Memory data will be cleared when the batteries are too low to take a measurement.
2. Memory data will be cleared when the batteries are replaced.
Page 6