Filter
Top Products
l If the START/STOP switch is pressed again during pressurization or during
the measurement, the pump will stop and the air will be released from the cuff.
3. When pressurization has been completed, the automatic exhaust mechanism
will gradually reduce the pressure in the cuff and the Measurement in Progress
symbol will appear along with the current pressure reading. This symbol will
blink in unison with the pulse of the person being monitored.
l The subject should remain still while the meter is in operation.
l The monitor will automatically pump to a higher pressure if the initial
starting pressure was insufficient. If needed, the start pressure can be
set manually. Press the START/STOP button and hold it down until the
display shows a pressure 30 to 40 mmHg above your normal systolic blood
pressure, then release. The meter will then start from that pressure. If you
have any questions, call customer service.
4. The Systolic Pressure is displayed on the upper portion of the display, the
Diastolic Pressure in the center of the display and the pulse in the lower
portion of the display.
Air Connector
Memory Switch
-
-
-
-
Systolic Display
Dwtolic Display
Pulse Display
Start/Stop Switch
Page 4