Filter
Top Products
Page 4SKU 93033 For technical questions, please call 1-800-444-3353.
Assembly
See the Assembly Drawing on page 10.
Mounting the Jack into the Lifting Frame.
1. Being careful not to damage the Release Pedal (26), secure the Jack (36) to the Jack
Mounting Plate with two Bolts (34). See FIGURE 1 and the Assembly Drawing.
2. Place the upper end of the Jack’s ram into the Lifting Frame (2), securing it with a Pin
with Spring Attached (39).
12. Never drop a load onto the Lift, may create for a brief instant, an excess load, which may
result in damage to the product and/or personal injury.
13. Not to be used for any aircraft purposes.
14. Always center the load on the Saddle Platform (5). Make sure the Platform does not
damage the motorcycle.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
Jack Mounting Plate
Release Pedal (26)
Foot Pedal (24)
Spring (41)
FIGURE 1
Jack (36)
Lifting Frame (2)
Pin with Spring
Attached (39)
Hidden From View
Unpacking
When unpacking, check to make sure the parts listed on pages 7 and 9 are included.
If any parts are missing or broken, please call Harbor Freight Tools at the number on the
cover of this manual as soon as possible.