Graham Field MM7174 Personal Lift User Manual


 
1. Remove the headboard panel assembly if
previously assembled to bed by pulling out
the Clevis Pins and Hair Pin Clips that attach
the main frame tubes to the headboard’s
mounting tubes and set aside.
2. Detach the headboard panel from the mounting
tubes by removing the four 1/4-20 x 1.5”
Machine Screws from the mounting tubes.
3. Assemble the Trapeze Support to the bed
frame using the two Clevis Pins and Hair
Pin Clips you previously removed from the
headboard’s mounting tubes.
4. Insert a 1/4-20 x 2.5” Carriage Bolt (#5) into
the vertical support as shown and fasten with
a 1/4-20 Hex Head Lock Nut (#6).
5. Assemble the headboard to Trapeze Support
using the supplied four 1/4-20 x 1.75” Machine
Screws (#3) from your hardware bag, threading
them through the headboard into the 1/4-20
inserts. DO NOT OVERTIGHTEN.
6.  <  #
Insert the Sleeve (#7) into the vertical support
with the slot on the bottom as shown. Rotate
the sleeve until it falls into place over the bolt
and into a locked position.  121).((7(8,..
%().64+8,5+5121)7(35,&$.4622135105+(
3$2(;('$2513
Item # Qty. Part # Description
1 1 999-0790-901G Trapeze Support Assembly
2 1 Headboard Headboard - 8” Boring
3 4 100-7025-004 1/4-20 x .60 Insert
4 4 100-5425-014
1/4-20 x 1.75” Phillips
Pan Head Machine Screw
5 1 100-5425-059
1/4-20 x 2.50”
Hex Head Cap Screw
6 1 100-6725-005 1/4-20 Hex Head Lock Nut
2D:4>6C:42?#65:42=&C@5F4ED25:G:D:@?@762=E9&C@5F4ED?4K#2EC:IK(,#2?F2= &
ccessory Assembly - Trapeze support
A
Assembly Kit# 999-0790-901
Tools Needed:
(1) 7/16” wrench & (1) phillips screwdriver