Filter
Top Products
Compass Owner’s Manual – Models GP600 SS, GP600 CC Revised 052313
16
ASSEMBLY
BATTERY INSTALLATION
The batteries weigh 24 to 39 pounds each (depending on type).
Please ask for help if you do not feel capable of safely lifting that much weight.
Figure 7 Figure 8
Figure 9a Figure 9b
Make certain that the controller power is turned off and that the chair
is NOT in freewheel mode before attempting to perform assembly or disassembly.
1. Place the batteries in the battery box. Be certain to position the terminals on each
battery toward the front of the unit as shown in Figure 7. Secure the batteries in
place using the hook and loop straps.
2. Use the screws, washers, and nuts provided to connect the positive (red booted)
connector of each cable to the positive (+) terminal of each battery. See figure 8.
3. Use the screws, washers, and nuts provided to connect the negative (black booted)
connector of each cable to the negative (-) terminal of each battery.
4. Connect the connectors of each battery cable to the corresponding connector on the
main wire harness. See figure 9a for NF22, figure 9b for U-1.
5. Cover the battery terminals with the protective caps provided. See figure 9a for NF22,
figure 9b for U-1.