Filter
Top Products
Compass Owner’s Manual – Models: GP600 SS, GP600 CC Revised 05/23/13
21
COMFORT SETTINGS
EXTENDING THE FOOTREST
Refer to the pictures below.
1. Insert a 5mm Allen wrench from the top side into the (2) adjustment screws.
2. Place a 10mm wrench on the backside onto the (2) nuts and loosen the (2) footrest
adjustment screws.
3. Slide the footrest plate to the desired position and tighten the adjustment screws.
NOTE: The maximum extended length is not at the end of the slots.
ARMREST ANGLE ADJUSTMENT
Refer to the picture below.
1. Lift armrest up.
2. Turn jam nut counter-clockwise to loosen.
3. Turn the adjustment bolt using a 6mm Allen wrench to raise or lower the armrest-
angle. Turning the bolt counter-clockwise will raise the angle. Turning the bolt
clockwise will lower the angle. Turn until desired angle is reached.
4. Re-tighten jam nut by turning clockwise.
5. Repeat steps 1-4 on the other armrest.
Footrest
Adjustment
Nuts
(
10mm
)
Footrest
Adjustment
Sc
r
ews
(5
mm
)
Bottom View
Top View
Jam Nut
Adjustment Bolt
(6mm Allen)