Filter
Top Products
Avenger Owner’s Manual
CARE AND MAINTENANCE
Main Circuit Breaker
The 50-amp circuit breaker and exposed reset button
AreA located under the battery cover. The button is visable
through the battery cover. If your Avenger™ fails to
operate, your main circuit breaker may have tripped.
WARNING: DO NOT ATTEMPT ELECTRICAL
REPAIRS. CONSULT GOLDEN TECHNOLOGIES
OR YOUR AUTHORIZED GOLDEN DEALER.
Possible causes for the main circuit breaker to trip:
• “Run-down” batteries.
• Over exerting the motor.
Possible solutions:
• Recharge your batteries.
• If the problem persists, have an authorized Golden dealer “load test” the
batteries to assure they are not damaged.
• If the problem persists, assure your battery charger is operating properly.
Resetting the Main Circuit Breaker
If the main circuit breaker trips as a result of “run-down” batteries or because of a
temporary overload, reset the circuit breaker using the following directions:
1. Wait 5 minutes to allow the motor and electronics board to cool, or return
to “normal” operating temperature.
2. Press in on the main circuit breaker reset button.
WARNING: BE SURE YOU REMOVE THE KEY FROM THE KEY RECEPTACLE BEFORE
RESETTING YOUR SCOOTER.
This is the
“LED” light
that will flash
in the event
of a problem.
Circuit Breaker
Found on the rear of
the unit next to the
freewheel brake
release.