Filter
Top Products
Avenger Owner’s Manual
DISASSEMBLY
Step 4 - Remove the battery cover – This will give you access to the batteries,
wire connections, and the main connection pin.
Step 5 - Unplug the following connections (see photos on the following pages).
1. Unplug the two gray battery connectors.
2. Undo the two Velcro retaining straps and remove batteries.
3. Unplug the large white main cable connector.
4. Unplug the small white charger connector.
5. Unplug the gray rear lights connector.
Step 6 - Remove safety retaining clip from the ball detent pin and pull pin out.
Step 7 - With one hand grab top of seat post, with your other hand grab curved
rear frame support member. Lift and separate front half from rear.
NOTE: The 3 wheeler breaks apart in a slightly different way in that
the seat post is on the rear frame.
AVENGER™ ASSEMBLY/DISASSEMBLY
WARNING: DO NOT SIT ON YOUR AVENGER™ UNLESS BALL
DETENT PIN IS INSERTED AND RETAINING CLIP RE-
INSTALLED IN BALL DETENT PIN.
WARNING: BE CAREFUL NOT TO PINCH YOUR
FINGER(S)
BETWEEN
FRAME HALVES
DURING RE-
ASSEMBLY.