Filter
Top Products
Avenger Owner’s Manual Revised 06/04/08
OPERATION
SEAT CONTROLS
Armrest Height Adjustments can be made by removing the 2
screws on the back of the armrest and raising to a comfortable
position and resetting the screws. The armrest can be raised 3”
and by replacing only 1 screw. You can raise the armrest and
replace both screws. You will require a 6mm allen wrench for this
task.
Armrest Width Adjustment
To adjust the armrest width:
1. Loosen the (2) 6mm adjustment screws at the rear of
each arm. Slide each arm to the desired width and tighten
the screws.
Seat Height Adjustment (Picture Not Shown)
To adjust the seat height: Lift up on seat rotate lever and turn
seat either left or right, lift seat straight up. Holding rotate
lever in the up position while lifting seat may make this task
easier. Remove 17mm machine screw and place seat post
at the desired height and re-insert screw.
Seat Rotation Lever
The seat can be rotated through 360° and locked at any
90° position.
1. Pull up on the seat rotate lever and rotate the seat
to the desired position.
2. Release the handle to lock the seat at any 90° position.
WARNING: DO NOT ATTEMPT TO DRIVE YOUR AVENGER
IN ANY SEAT POSITION OTHER THAN FULLY FORWARD.
Flip-Up Armrests
Pull up on the end of either armrest to flip it up for easy
transfer on and off your Golden Avenger™.
Seating
The Golden Avenger™ seat is available only in gray vinyl.