Filter
Top Products
CHAPTER 2
OPERATING INSTRUCTIONS
2.1 BATTERY CHARGING PROCEDURE
our AGRI-THERM II has been charged at the factory before shipment.
However, you may want to charge it again overnight before extended use. To
recharge the batteries in your AGRI-THERM II Infrared Thermometer, plug the
plug on the end of the six-foot lead of the supplied battery charger into the Rear Panel
Jack of the infrared thermometer labeled “BATT.” The “BATT” jack can be found on
the left hand side of the Rear Panel. Then, plug the AC adaptor into 90-250 Volt AC
50/60 Hz power source.
Y
Allow ten (10) hours for a complete charge; partial charges are okay. When charging is
complete, unplug the AC adaptor from the outlet and then remove the plug from the
instrument.
2.2 ABBREVIATIONS ON REAR PANEL
he abbreviations on the Rear Panel of the AGRI-THERM II stand for the
following:
T
9 SEL = Select: IR, DIFF or AMB
9 IR = Infrared Surface Temperature Reading
This is the current infrared surface temperature reading of the target
that the instrument is focused on.
9 DIFF = Temperature Differential
This is the Difference between the Dry Bulb Ambient Air Temperature
and the Temperature of the target.
9 AMB = Dry Bulb Ambient Air Temperature
This is the temperature of the ambient air surrounding the Infrared
Thermometer.
9 PWR = Power: On/Off
9 LITE = TTL Intra-Optical Light Sighting: On/Off
9 DATA = Plug for outputting the data selected by “SEL” at the rate of
10mV/º.
9 BATT = Place to plug in battery charger.
5