Filter
Top Products
Check upholstery at least once a month. Inspect for rips, tears and
worn spots. Ensure that all upholstery-attaching screws are present,
properly aligned, and well-secured. Use a Phillips screwdriver to tighten
upholstery mounting screws. Check attaching screws for sharp edges or
stripped screws, and replace if found.
WARNING: Worn or torn upholstery, or upholstery with loose
hardware, must be replaced immediately. It may not support
body weight.
Inspect the wheels at least once a month. Check alignment by elevating
the rear of the wheelchair on a stable object until the rear wheels clear
the ground, or placing the wheelchair upside down in a stable position
such that the wheels can spin freely. Spin the wheels; there should be no
wobble or sideplay, and the wheels should spin freely without binding.
The bearings should be clean and rotate smoothly. Check rim sideplay
to verify that bearings are not too loose. If there is a problem, contact
your Graham-Field authorized distributor. If adjustment is required, this
should be done by your Graham-Field distributor only.
Check arms at least once a month. Inspect for sharp edges or cracks
which could weaken the arm, and replace if found. Ensure that all
attaching screws are present and tight. Use a Phillips screwdriver to
tighten arm pad mounting screws. Check for burrs on the screw heads
and replace if found. Ensure that screws do not extend into the padding.
Confirm that the posts at base of arm fit correctly in the sockets, snug but
not binding.
Check backposts at least once a month. Ensure that all mounting
hardware is securely fastened and that the backposts are not bent or
damaged. Contact your authorized distributor if you observe cracking or
peeling paint or plating.