Filter
Top Products
Always hold the tool with two hands during start-
up
. The reaction torque of the motor can cause the
tool to twist.
Always wear safety goggles and dust mask. Use
only in well ventilated area.
Using personal safety
devices and working in safe environment reduces
risk of injury.
After changing the accessories or making any
adjustments, make sure the collet nut and any
other adjustment devices are securely tightened.
Loose adjustment device can unexpectedly shift,
causing loss of control, loose rotating components
will be violently thrown.
Do not reach in the area of the spinning accesso-
ry.
The proximity of the spinning accessory to your
hand may not always be obvious.
Never start the tool when the accessory is engaged
in the material.
The accessory may grab the
material causing loss of control of the accessory.
Do not leave a running tool unattended, turn power
off.
Only when tool comes to a complete stop it is
safe to put it down.
Do not sand near flammable materials. Sparks
from the acessory could ignite these materials.
Do not touch the bit or collet after use. After use the
bit and collet are too hot to be touched by bare
hands.
Regularly clean the tool's air vents by compressed
air.
Excessive accumulation of powdered nail inside
the motor housing may cause electrical failures.
Do not allow familiarity gained from frequent use
of your tool to become commonplace.
Always
remember that a careless fraction of a second is suf-
ficient to inflict severe injury.
Do not alter or misuse tool. Any alteration or mod-
ification is a misuse and may result in serious per-
sonal injury.
This product is not intended for use as a dental
drill, in human or veterinary medical applica-
tions.
Serious injury may result.
Some dust created by power
sanding, sawing, grinding,
drilling, and other construction activities con-
tains chemicals known to cause cancer, birth
defects or other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and
other masonry products, and
• Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilat-
ed area, and work with approved safety equipment,
such as those dust masks that are
specially designed tofilter out microscopic particles.
Page 4
!
WARNING