Filter
Top Products
Page 14
Set the speed indicator to fit the job to achieve the
best job results when working with different
materials.
To select the right speed for each job, use a prac-
tice piece of material. Vary speed to find the best
speed for the accessory you are using and the job
to be done.
On the Model 761, there is a LO and HI switch.
When the switch indicator is in position 1 or LO, the
tool runs at about 7,000 RPM. When the switch
indicator is in position 2 or HI, the tool runs at about
14,000 RPM.
NOTE: Speed is affected by voltage changes.
Weaker batteries with reduced voltage will slow the
RPM of the tool, especially at the lowest setting. If
your tool appears to be running more slowly than
normal, replace the batteries with fresh ones to
increase tool speed.
Most applications using the 761 Pet Nail Grooming
Tool can be accomplished using the LO speed set-
ting (position 1). The LO speed setting (position 1)
is recommended when using the 431 sanding drum
included with the tool. HI speed is needed only for
larger animals or nail buffing applications.
The speed of Model 761 is controlled by
setting this indicator on the housing.
761 Pet Nail Grooming Tool Accessories
The 761 Pet Nail Grooming Tool can be outfitted
with different Dremel accessories to perform a
variety of nail grooming tasks. Included below are
descriptions of popular Dremel accessories used
with the 761 tool.
1/4” Sanding Drum (included)
One #430 Dremel 1/4” sanding drum and four
#431 60-grit sanding bands are included with the
Dremel Pet Nail Grooming Tool.
Tip: The #430 1/4” sanding drum works best on
cats and small to medium sized dogs.
Other Accessories (not included)
1/2” Sanding Drum
The #407 Dremel 1/2” sanding drum equipped
with a 1/2” 120-grit or 60-grit sanding band is
useful for larger breed dogs.
Operating Speeds For Accessories