Filter
Top Products
- Eng 23 -
English
Make sure to check the following before sending your blood pressure monitor away
to be tested or repaired.
Problem Checks Response
Display stays blank when
you press the “START/
STOP” switch.
Check whether the
batteries are dead.
Replace all the batteries
with new ones.
Check whether the
batteries are installed the
right way round (
and
oriented correctly).
Load the batteries in the
correct direction.
No measurements can
be taken.
Check whether the
measurement icon is
displayed.
Attach the arm cuff
properly.
Check whether the arm
cuff is applied correctly.
Did you stay calm during
measurement?
Measure your blood
pressure again, making
sure to remain still.
Note that blood pressure measurement may not be
possible for someone with an extremely weak pulse
or cardiac arrhythmia (irregular pulse).
Your blood pressure readings are abnormally high or
low compared with those taken in hospital.
See page 22.
Other phenomena
Remove the batteries from
the unit and change them
with new ones.
BEFORE REQUESTING REPAIRS OR TESTING