Citizen CH-461C Blood Pressure Monitor User Manual


 
- Eng 18 -
English
MEASURING YOUR BLOOD PRESSURE
Wait a while after the completion of pressurization. Then,
the
mark comes on and the unit automatically starts
measuring your blood pressures.
When the unit detects your pulse, the
mark fl ashes on
and off, then the unit gives your blood pressure value on
the lower section of the display.
Upon completion of measurement, the unit automatically
exhausts air from the cuff. Then, the Systolic blood
pressure/Diastolic blood pressure/pulse will appear on
display.
As long as the unit functions correctly, the blood pressure
and the pulse rate for the result with the record of the time
and date are automatically stored in memory as one set of
data.
Up to 7 sets of measurement data can be stored in the
memory. If you measure your blood pressure when 7 sets
of measurements have already been stored in memory, the
earliest set of measurements is automatically deleted to
make way for the new measurements.
The Blood pressure monitor automatically carries out
pressurization until the pressure that is best suited to the
blood pressure measurement is reached.
When the unit determines that an adequate pressure is not
obtained, the unit starts pressurization again.