Braun NUVL855R Wheelchair User Manual


 
Page 4
7KHIROORZLQJRSHUDWLRQVDQGFRQGLWLRQVPXVWEHIXQFWLRQDOO\YHULÀHGLQRUGHUIRUWKHOLIWWREH)0966
403/404 compliant. If an operation does not function as described or a condition is not met, follow the refer-
enced procedures to correct the problem or contact a Braun Corporation Product Support representative at
7+(/,)7
®
.
9HKLFOHPRYHPHQWLVSUHYHQWHGXQOHVVWKHOLIWGRRULVFORVHGHQVXULQJWKHOLIWLVVWRZHG
9HULI\OLIWVWRZHGVLJQDOSLQLQWKHFRQGXFWRUSOXJRQWKHVLGHRIWKHSXPSPRGXOHKDVDYROW
signal.
2. Refer to the interlock installation instructions.
• Lift operation shall be prevented unless the vehicle is stopped and vehicle movement is prevented.
9HULI\YHKLFOHVHFXUHVLJQDOSLQLQWKHFRQGXFWRUSOXJRQWKHVLGHRIWKHSXPSPRGXOHKDVD
volt signal.
2. Refer to the interlock installation instructions.
• The platform will not fold/stow when occupied.
- Refer to Platform Sense Calibration.
• The inner roll stop will not raise if occupied.
- Refer to Inner Roll Stop Occupied Sensor Adjustment
• The outer barrier will not raise if occupied.
- Refer to Outer Barrier Occupied Calibration procedure
9HULI\SODWIRUPOLJKWLQJZKHQOLIWLVGHSOR\HGDQGSHQGDQWLOOXPLQDWLRQZKHQOLIWLVSRZHUHG
1. Replace bulb(s) in the light housing.
2. Check inline fuse on wires going out to lights.
• A visual and audible warning will activate if the threshold area is occupied when the platform is at least 1"
EHORZÁRRUOHYHO
1. Make sure connectors to threshold mat are properly connected.
2. Call Product Support.
• Platform movement is prohibited beyond the position where the inner roll stop is fully deployed (up).
- Call Product Support.
• Lift platform movement shall be interrupted unless the outer barrier is deployed (up).
- Check Barrier Down limit switch, wires and connector.
- LED D29 should not be illuminated when outer barrier is deployed (up).
Certification Checklist Diagnostic Procedures