Braun 5 Mobility Aid User Manual


  Open as PDF
of 32
 
Page 8
Platform Floor Level Adjustment
'LDJQRVWLFV'LDJQRVWLFFRGHV
have been established in event
WKHOLIWSODWIRUPÁRRUSRVLWLRQ
does not set (the lift does not
sound three “beeps” - see Step
5 above). The control board
located inside the pump hous-
91 – The platform position is out of a prede-
termined acceptable range
92 – The Bridging Microswitch is not activat-
ed (adjust switch or lower the platform)
93 – The Inner Roll Stop Occupied switch is
not activated (adjust switch)
94 – The Outer Barrier Up switch is not acti-
vated (adjust switch)
95 – The Outer Barrier Latched sensor is
not activated (Century and Vista: Verify
jumper is installed on the outboard
barrier latch switch – see photo at right;
Millennium: Check latch)
/&'6FUHHQ
)ORRU/HYHO6HW%XWWRQ
E
)
)ORRU/HYHO$GMXVWPHQW
1. Position platform at desired
ÁRRUOHYHOSRVLWLRQSDVVHQJHU
loading/unloading height).
Position platform such that:
a. the inner roll stop is laying
ÁDWRQWKHWKUHVKROGSODWH
b. platforrm has not begun to
fold
Note: Use hand pump to po-
sition platform at proper posi-
tion if unable to stop platform
when powering lift.
2. Turn Lift Power switch Off.
3UHVV)ORRU3RVLWLRQ6HWEXW-
ton (located between pump
housing and lift tower).
:KLOHSUHVVLQJWKH)ORRU3R-
sition Set button, turn the Lift
Power switch On.
&RQWLQXHSUHVVLQJWKH)ORRU
Position Set button until the
lift sounds three “beeps.”
5HOHDVHWKH)ORRU3RVLWLRQ
Set button.
7. Cycle lift to verify that plat-
IRUPVWRSVDWWKHVHWÁRRU
level position. Note: If
platform does not stop at
%HIRUHVHWWLQJÁRRUOHYHOSRVLWLRQ
• Adjust platform angle as detailed
on page 6.
• Ensure both VWRSEORFNVDUH
PDNLQJIXOOFRQWDFWZLWKYHUWL-
cal arms (details on page 7).
the intended position - repeat
adjustment procedures. If re-
peating procedures fails - refer
WR'LDJQRVWLFVVHFWLRQEHORZ
LQJLVHTXLSSHGZLWKDQ/&'
screen. Remove the pump
FRYHUWRDFFHVVWKH/&'
screen. The following diagnos-
WLFFRGHVZLOOKHOSUHVROYHÁRRU
position setting problems:
Century/Vista Jumper
 previous next