Filter
Top Products
11
www.ascensia.ca
Then insert the lancet fi rmly
until it comes to a full stop.
This will “cock” the device.
4. Twist off the lancet cap and
replace the endcap.
Push Out Test Strip
5. Your Breeze Meter uses
a special, easy-to-use “Pull
and Push” design.
Here’s how it works:
Hold the meter comfortably in
one hand. Firmly grasp the
meter handle with the other
hand (shown here). Now, just
“Pull and Push”—“Pull” the
handle out until it stops and
“Push” it back in until it
stops again.
Helpful Hint: There is no need to turn the meter on—
just “Pull and Push.”