Filter
Top Products
Measurements
Model UA-767 30 is designed to detect the pulse and to inflate the
cuff to a systolic pressure level automatically.
If your systolic pressure is expected to exceed 230 mmHg or you use the
optional small cuff, read "Measurement With The Desired Systolic
Pressure" on next page.
Normal Measurement
1. Place the cuff on the arm (preferably the left arm).
At heart level
Starts inflation
Pressurizing
Measurement
in progress
Systolic pressure
Diastolic pressure
WHO classification
Pulse rate
START button
A
veraged data
Data number
Sit quietly during measurement.
2. Press the START button.
The average blood pressures and last data
number are displayed briefly. Then the
display changes, as indicated in the figure
at the right, as the measurement begins.
The cuff starts to inflate. It is normal for the
cuff to feel very tight. A pressure bar
indicator is displayed, as in the figure at
the right, during inflation.
Note: If you wish to stop inflation at any time,
press the
START button again.
3. When inflation is complete, deflation starts
automatically and the
(heart mark)
blinks, indicating that the measurement is
in progress. Once the pulse is detected,
the mark flashes with each pulse beat.
Note: If an appropriate pressure is not
obtained, the device starts to inflate
again automatically.
4. When the measurement is complete, the
systolic and diastolic pressure readings and
pulse rate are displayed. The cuff exhausts
the remaining air and deflates completely.
5. Press the START button again to turn
off the power.
Note: Model UA-767 30 is provided with an automatic power
shut-off function. Allow at least ten minutes between
measurements on the same person.
Exhausts remaining
air automatically
English 8