20
Before Operation (Continued)
TV Aspect
4:3 Letter Box: Select when a standard 4:3 TV is con-
nected. Displays theatrical images with masking bars
above and below the picture.
4:3 Pan Scan: Select when a standard 4:3 TV is con-
nected. Displays pictures cropped to fill your TV screen.
Both sides of the picture are cut off.
16:9 Wide: Select when a 16:9 wide TV is connected.
Progressive Scan
Progressive Scan Video provides the highest quality
pictures with less flickering.
• If you are using the COMPONENT/PROGRESSIVE
SCAN VIDEO OUT jacks, but are connecting the
VCR/DVD Recorder to a standard (analog) televi-
sion, set Progressive Scan to OFF.
• If you are using the COMPONENT/PROGRESSIVE
SCAN VIDEO OUT jacks for connection to a TV or
monitor that is compatible with a progressive scan
signal, set Progressive Scan to ON.
Caution
Once the setting for Progressive Scan output is entered,
an image will only be visible on a Progressive Scan
compatible TV or monitor. If you set Progressive Scan
to ON in error, you must reset the VCR/DVD Recorder.
First, remove the disc in the VCR/DVD Recorder. Next,
press STOP (x) and hold it for five seconds before
releasing it. The video output will be restored to the
standard setting, and a picture will once again be visible
on a conventional analog TV or monitor.
Factory Setting
If you wish, you can reset the VCR/DVD Recorder to its
original factory settings. Select “SET” then press
ENTER (
).
The Initialize menu will appear. Use the b B buttons to
select “Yes” and press ENTER (
).
Note :
Some options cannot be reset. (Movie Rating, Password and
Country Code)
LANGUAGE
Display Menu
Select a language for the Setup menu and on-screen
display.
Disc Language
Select a language for the disc’s Menu, Audio, and Subtitle.
Original : The original language set for the disc is selected.
Other : To select another language, select Other option then
press ENTER (
). Use the numbered buttons to key-in the
corresponding 4-digit number according to the language code
list on page 54. If you enter the wrong number, press b repeat-
edly to delete one by one and correct it.
CH. Add/Del
Prev. Select Close
CH. Add/Del
Prev. Select Close
CH. Add/Del
Prev. Select Close
It initializes the system status.
Prev. Select Close
Prev. Select Close
