A SERVICE OF

logo

Dealer Service 35
MAN0577 (6/29/2007)
Figure 18. Crossbar Removal
Crossbar Installation
1. Using emery cloth (220 or finer), remove surface
rust, and foreign material from hub, splined
gearbox vertical shaft, and crossbar. See Figure
19.
Figure 19. Typical Crossbar and Gearbox Shaft
2. Install crossbar (2) on splined shaft. See Figure 20.
Install nut (3). Torque nut to 450 lbs-ft. Install cotter
pin.
Figure 20. Crossbar Installation
1. Clevis
2. 5/8 NC x 4 Cap screw
3. 5/8 NC Hex nut
4. Pad assembly
5. Tube assembly
6. Screw assembly
7. Puller link