1. Turn power ON
Push [POWER] for 1 sec. to turn
power ON.
•Opening message is displayed for 1
sec.
BASIC OPERATION
3
10
■ General
Operating the IC-R10 is easy. However,
in order to get the most out of its oper-
ating potential, please go through the
following procedures, step-by-step.
Then, try the examples contained at the
end of this chapter.
What is VFO?
The IC-R10 has several operating
modes, each of which has its own dis-
tinct functions. VFO (Variable
Frequency Operation) is one of these
modes.
VFO mode is used to change the oper-
ating frequency, receive mode, tuning
step, etc. Therefore, for most every day
operations of the receiver, you will be
using VFO mode.
■ Selecting VFO mode
2. Adjust the volume
Adjust the audio to a suitable level
using [VOL].
Check the squelch position (see next
page) or VSC function setting (p. 38)
if no audio is emitted.
