11- ENG
A08987
8. Start engine. See Engine
Owner's Manual for correct
procedure.
NOTE: When engine
rope is pulled, pressure starts
building in the gun. If the engine
does not start after two pulls,
pull the gun trigger to relieve this
pressure.
9. Depress trigger on gun to
start water flow.
NOTE: Stand
on a stable surface and grip
gun/spray wand firmly with both
hands. Expect the gun to kick
when triggered.
10. Release trigger to stop water
flow.
11. Adjust nozzle spray for the
task being performed. See How
To Use Wand instructions in this
section.
SHUTTING DOWN
1. After each use, if you have
applied detergents or cleaning
solvents, place end of detergent/
cleaning solvent hose into
container of clean water and draw
clean water through detergent
injection system to rinse system
thoroughly.
NOTE: Failure to do
so could cause damage to the
pump.
2. Turn engine off.
See Engine
Owner’s Manual.
NOTE: NEVER
turn the water off with the engine
running.
3. Turn water supply off.
4. Pull trigger on spray gun
to
relieve any water pressure in hose
or spray gun.
5. See Storage section
in this
manual for proper storage
procedures.
MAINTENANCE
When performing
maintenance, you
may be exposed to hot surfaces,
water pressure, or moving parts
that can cause serious injury or
death!
Before performing any maintenance
or repair, disconnect spark plug
wire, let engine cool and release
all water pressure. The engine
contains flammable fuel.
DO NOT
smoke or work near open flames
while performing maintenance.
To ensure efficient operation and
longer life of your pressure washer, a
routine maintenance schedule should
be prepared and followed. If the
pressure washer is used in unusual
conditions, such as high-temperatures
or dusty conditions, more frequent
maintenance checks will be required.
ENGINE
Consult the Engine Owner's
Manual for the manufacturer's
recommendations for any and all
maintenance.
PUMP
The pump on this unit is maintenance
free and requires no oil. If there is a
problem with the pump call
1-866-4SIMONIZ (1 866 474 6664).
NOZZLE CLEANING
If the nozzle becomes clogged
with foreign matter, such as dirt,
excessive pressure may develop. If
the nozzle becomes partially clogged
or restricted, the pump pressure will
pulsate. Clean the nozzle immediately
using the nozzle kit supplied and the
following instructions:
