11
“TON DIR” is displayed and the sound that
bypasses the tone circuitry will be heard.
To cancel the tone direct function, press this button
again to display “TON CTRL”.
To listen to a program source without the tone effect.
10
Each time this button is pressed, the corresponding
tone mode is selected and shown for 3 seconds as
follows:
BASS TRBL
Note:
When the tone direct function is activated, the tone
mode cannot be entered and “TON DIR” flickers
for 3 seconds.
Enter the tone mode.
8
If the tone display disappears, start from the step 8
again.
When pressing the TREBLE UP/DOWN(+/-) or
BASS UP/DOWN(+,-) buttons, you need not
select the desired tone mode on the step 8.
Notes:
Extreme settings at high volume may damage your
speakers.
In general, the bass and treble levels are adjusted
to 0.
At the desired tone mode, adjust the tone
as desired.
9
Adjusting the tone(bass and treble)
“BAL” and the balance level is displayed for 3
seconds.
Enter the balance mode.
11
If the balance display disappears, start from the
step 11 again.
Note:
In general, the balance level is set to 0.
Adjust the sound volume balance between
the left and right speakers.
12
Adjusting the sound volume balance
“MUTE” lights up and flickers.
To resume the previous sound level, press this button
again.
To mute the sound.
6
Be sure to switch off both A and B speakers.
To listen with the headphones.
7
