Senatek International LS100 Manual

A SERVICE OF

next previous

22

2.4.5 ‘save’ Command

With ‘save’ command, current parameter changes are saved to non-volatile memory. Command usage

of ‘save’ command is as follows:

save + <CR>

Saved changes will be applied if the LS100 is rebooted by ‘reboot’ command or manual rebooting.

2.4.6 ‘exit’ Command

With ‘exit’ command, current serial or remote console session will be closed. However, changed

parameters are not applied until the LS100 is manually rebooted. Command usage of ‘exit’ command

is as follows:

exit + <CR>

2.4.7 ‘reboot’ Command

With ‘reboot’ command, the LS100 will be rebooted immediately. Changed parameter values will be

applied when the LS100 is up again. Command usage of ‘reboot’ is as follows:

reboot + <CR>