Rear
1
Audio Out For outgoing audio signals.
2
Audio In For incoming audio signals.
3
SDHC Memory Card Slot This is where you insert your SDHC memory card.
4
System, SD, and Power
Indicators
These indicators provide system, SD, and power status
information.
5
I/O Port
Used to connect the camera to an external device.
A_IN 1 and 2: These are alarm in ports.
GND: This is the GND port.
A_OUT 1 and 2: These are alarm out ports.
NOT USED: This port is not used.
6
Reset Button
Reverts all camera settings to their default.
When it is pressed for 3 seconds, the system indicator goes
out and the system reboots.
When the camera is reset, connection is possible only after the
basic network settings (IP address, subnet mask, gateway, etc.)
have been configured again using the IP installer program.
7 86 5
4
3
2
1
NA-M300-ENG_AB68-00721A.indd 6 2008-11-17 오후 5:33:03
