A SERVICE OF

logo

Open as PDF
next previous
51
Eect Settings (EFFECT)
16: LIMITER
Compresses signals that exceed a specied volume level, preventing distortion from
occurring.
L in
R in
L out
R out
Limiter
2-Band EQ
2-Band EQ
Limiter
Parameter Value Description
RELEASE # 0–100
Adjusts the time after the
signal volume falls below
the THRESHOLD level until
compression is no longer
applied.
THRESHOLD # 0–100
Adjusts the volume at which
compression begins.
RATIO # 1.5:1, 2:1, 4:1, 100:1 This sets the compression ratio.
POST GAIN # 0–+18 dB Adjusts the output gain.
LOW GAIN -15–+15 dB Adjusts the gain of the low range.
HIGH GAIN -15–+15 dB
Adjusts the gain of the high
range.
LEVEL 0–100 Adjusts the output volume.
17: 3TAP PAN DELAY
Produces three delay sounds; center, left and right.
L in
R in
L out
R out
Left Tap
Right Tap
Triple Tap Delay
2-Band
EQ
2-Band
EQ
Balance W
Balance D
Balance W
Balance D
Feedback
Center Tap
Parameter Value Description
DELAY LEFT/RIGHT/
CENTER #
1–2600 msec,
BPM
–
Adjusts the time from the
original sound until the left,
right, and center delayed sounds
are heard.
CENTER FEEDBACK # -98–+98%
Adjusts the amount of the delay
sound that’s fed back into the
eect. Negative (-) settings invert
the phase.
HF DAMP 200–8000 Hz, BYPASS
Adjusts the frequency above
which sound fed back to the
eect is ltered out. If you do
not want to lter out any high
frequencies, set this parameter
to BYPASS.
LEFT/RIGHT/CENTER
LEVEL
0–100
Adjusts the volume of each
delay.
LOW GAIN -15–+15 dB
Adjusts the gain of the low
range.
HIGH GAIN -15–+15 dB
Adjusts the gain of the high
range.
BALANCE D100:0W–D0:100W
Adjusts the volume balance
between the direct sound (D)
and the chorus sound (W).
LEVEL 0–100 Adjusts the output volume.
18: TIME CTRL DELAY
A stereo delay in which the delay time can be varied smoothly.
R in
R out
L in
L out
Feedback
Feedback
Pan L
Pan R
Time Ctrl Delay
Time Ctrl Delay
2-Band EQ
2-Band EQ
Parameter Value Description
DELAY TIME #
1–1300 msec,
BPM
–
Adjusts the time until the delay
sounds are heard.
ACCELERATION # 0–15
Adjusts the speed at which the
delay time changes from the
current setting to a specied new
setting. The rate of change for
the delay time directly aects the
rate of pitch change.
FEEDBACK # -98–+98%
Adjusts the amount of the delay
that’s fed back into the eect.
Negative (-) settings invert the
phase.
HF DAMP 200–8000 Hz, BYPASS
Adjusts the frequency above
which sound fed back to the
eect is ltered out. If you do
not want to lter out any high
frequencies, set this parameter
to BYPASS.
LOW GAIN -15–+15 dB Adjusts the gain of the low range.
HIGH GAIN -15–+15 dB
Adjusts the gain of the high
range.
BALANCE # D100:0W–D0:100W
Adjusts the volume balance
between the direct sound (D)
and the chorus sound (W).
LEVEL 0–100 Adjusts the output volume.