40
Eect Settings (EFFECT)
Changing the Structure/Specifying
the Connection Destination
If you want to change the way in which the eects are arranged, you
can switch the structure.
The GR-55 provides two structures, which have the following features.
STRUCTURE 1
This structure uses AMP+MOD and MFX in parallel.
Use this structure when you want to apply the eects
separately; the MFX eect to the synthesizer sound, and
the AMP+MOD eects to the guitar modeling sound.
STRUCTURE 2
This structure connects AMP+MOD and MFX in series.
Use this structure when you want to apply the MFX eect
to the entire patch, and both the AMP+MOD eects and
the MFX eect to the guitar modeling sound.
1. In step 5 of “Switching the Eect Type,” select the eect that
you want to edit.
2. Press the [ENTER] button.
The EFFECT EDIT screen will appear.
Changing the structure
3. Use the PAGE [ ] [ ] buttons to select the STRUCT tab.
4. Use the cursor buttons to move the cursor to the position
shown in the illustration.
5. Use the dial to change the structure.
Specifying the connection destination of the tones
6. Use the cursor buttons to move the cursor to the position
shown in the illustration.
If the border is a dashed line, the tone switch is
turned o. You can set the tone switch in the TONE
tab of the EDIT screen (p.23).
7. Use the dial to change the connection destination of the
tone.
Setting Description
BYPS The tone will not use MFX, AMP, or MOD.
AMP The tone is connected to AMP.
MFX The tone is connected to MFX.
8. When you’ve nished editing, press the [EXIT] button.
9. If you want to keep the changes you made, save the patch
(p.60).
10.
