73
Selecting and Playing Sounds
Selecting and Playing Sounds
1.
The volume levels of each part are adjusted using the
corresponding [
▲
] and [
▼
] buttons.
Pressing the upper button ([
▲
] button) will increase the volume.
Pressing the lower button ([
▼
] button) will decrease the volume.
The volume can be set to any value from 0 to 12.
When the volume value shown in the display is 0, that part will produce no
sound.
You can also press the [
▲
] button or [
▼
] button of the part whose volume you
wish to adjust, so that the “Part Balance Monitor screen” is displayed for
several seconds, allowing you to check the volume balance.
fig.01-27.eps
You can check the volume by viewing the Level indicators of each part.
fig.01-27-2.eps
The Part Balance Monitor
screen is displayed for several
seconds and then closes
automatically.
If you touch <Hold>, the screen
continues to be displayed until
ou touch <Exit>.
AT-800_e.book 73 ページ ２００８年１０月１５日 水曜日 午前９時３７分
