Setting Up the Machine on a Network
39
2
❖ Ping Command
Check the network connection
with ping command using given
IP address.
Note
❒ If you fail to connect to the net-
work, check the following, and
then retry the ping command.
• Check TCP/IP of the printer
is active.
• Check that the machine with
assigned IP address is con-
nected to the network.
• There is a possibility that same
IP address is used for the spec-
ified equipment .
❖ Permit SNMP V3 Communication
Set the encrypted communication
of SNMP v3.
• Encryption Only
• Encryption / Clear Text
Note
❒ If you set to [Encryption Only],
you need to set password for
the machine.
❖ Permit SSL / TLS Communication
Set the encrypted communication
of SSL/TLS.
• Ciphertext Only
• Ciphertext Priority
• Ciphertext / Clear Text
Note
❒ Default: Ciphertext Priority
❒ If you set to [Encryption Only], you
need to install the server authen-
tification for the machine.
❖ Host Name
Specify the host name.
❖ Machine Name
Specify the machine name.
IEEE 1394
Preparation
You must install the optional IEEE
1394 interface board in the ma-
chine.
❖ IP Address
When you connect the machine to
a network using the IEEE 1394 in-
terface, you must configure the IP
address and subnet mask.
• Auto-Obtain (DHCP)
• Specify
When you select [Specify], enter
the [IP Address] and [Sub-net
Mask] as “xxx.xxx.xxx.xxx”(“x”
indicates a number).
• IP Address: 011.022.033.044
• Sub-net Mask: 000.000.000.000
Note
❒ Default: Auto-Obtain (DHCP)
❒ If you use the interface for Eth-
ernet and IEEE 1394 (IP over
1394) at the same time, settings
must be made carefully. See
p.139 “Using DHCP”
❒ When you use the IEEE 1394 in-
terface on a network, you can-
not use the Ethernet interface in
the same domain. To use both
interfaces in the same domain,
set different values for the [Sub-
net Mask].
❒ The physical address (EUI-64)
also appears.
❖ DDNS Configuration
You can specify the DDNS set-
tings.
• Active
• Inactive
❖ Host Name
Specify the host name.
