14
CONTROLS
Fuel Shut Off Valve
The fuel shut off valve is located at the left rear of the seat. The
valve is off when the handle tab is turned perpendicular to the
fuel line.
Seat Adjustment Lever Cutting Height Adjuster
IMPORTANT INFORMATION To obtain an even cutting
height, it is important that the air pressure in all tires is 15
psi / 103 kPa / 1 bar.
IMPORTANT INFORMATION Always raise the deck to the
highest position for transport.
The desired cutting height is set with the height pin. The
cutting height pedal releases the deck lift to place the deck at
the selected height.
For transport, push the deck lift pedal fully forward until the
deck lift latches in the transport (highest) position.
IMPORTANT INFORMATION Do not adjust the seat while
the unit is in motion.
The seat can be adjusted lengthways. The lever under the front
edge of the seat is moved to the left (as seen by the driver in
the seat), to adjust the seat backward or forward.
Hydro Release Levers
WARNING! Bypass linkages are located close to
the muffler. To prevent burns, the engine should be shut off
and allowed to cool before the bypass linkage levers are
handled.
Transaxle bypass linkages must be engaged when pushing or
pulling the mower. The release levers are located on each side
of the rear of the unit below the rear engine plate. See Manual
Transport in the Operation section.
