8 EN
3 Before use
Place the product
Place the speakers at an angle of approximately
45 degrees from the listening position.
Note
• To avoid magnetic interference or unwanted noise,
never place this product too close to any radiation
devices.
Connect speakers
Note
• Make sure that the colors of the speaker wires and
terminals are matched.
• For optimal sound, use the supplied speakers only.
• Connect only speakers with impedance that is the
same or higher than the supplied speakers. Refer to the
chapter "Specications" in this manual.
1 Hold down the socket ap.
2 Insert the stripped part of the wire
completely.
• Insert the right speaker wires to "R",
left speaker wires to "L".
• Insert the red wires to "+", black wires
to "-".
3 Release the socket ap.
Connectpower
Caution
• Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back or the underside of the product.
• Risk of electric shock! When you unplug the AC power
cord, always pull the plug from the socket. Never pull
the cord.
• Before you connect the AC power cord, make sure that
you have completed all other connections.
Connect the power plug to the wall outlet.
Install/replace the remote
control batteries
Caution
• Risk of explosion! Keep batteries away from heat,
sunshine, or re. Never discard batteries in re.
