10 EN
Set clock
1 In standby mode, press and hold
PROG/CLOCK SET to activate clock
setting.
» [CLOCK SET] (set clock) scrolls on
the display, and then [CLOCK 24]
(24-hour time format) is displayed with
"24" blinking.
2 Press / or VOL +/- to select
[CLOCK 24] or [CLOCK 12] (12-
hour time format), and then press
PROG/CLOCK SET.
» The hour digits begin to blink.
3 Press / or VOL +/- to set the hour.
4 Press PROG/CLOCK SET again.
» The minute digits begin to blink.
5 Press / or VOL +/- to set the minute.
6 Press PROG/CLOCK SET to conrm the
clock setting.
» The set clock is displayed.
• To exit clock setting without storing,
press
.
Note
• If no button is pressed in 90 seconds, the system exits
clock setting mode automatically.
Tip
• To adjust the digits of hour or minute, you can also turn
the VOLUME knob or press PRESET/ALBUM +/- on
the main unit.
Demonstrate features
1 In normal standby mode, press .
• [WELCOME TO PHILIPS] (welcome
to Philips) scrolls on the display, and
then feature names one by one.
2 To exit the feature demonstration, press
again.
5 Play
Play a disc
Caution
• Risk of damage to the product! During play, never move
the product.
• Never put any object other than a disc into the disc
compartment.
• Never look at the laser beam inside the player.
• Never play discs with accessories such as disc stabilizer
rings or disc treatment sheets.
1 Press CD to select the disc source.
2 Load a disc.
1) Press to eject the disc tray.
2) Place a disc onto the disc tray with its
label facing up.
3) Press to close the disc compartment.
3 Press if the play does not start
automatically.
Play from a USB storage
device
This product can play les that are copied onto
a supported USB storage device:
• ash drive
• memory card reader
• HDD (This product can only detect a
portable hard disc drive with the peak
current no higher than 500 mA through
the USB socket.)
Note
• Philips does not guarantee compatibility with all USB
devices.
• NTFS (New Technology File System) data format is not
supported.
