99
3
Taking Pictures
4
Use the four-way controller (23)
to select [Interval], [Number of
Shots] or [Start Delay].
5
Press the four-way controller (5), then use the four-
way controller (23) to change the settings.
To change another setting, press the four-way controller (5).
6
When finished, press the 3 button.
The screen shown in Step 3 reappears.
The camera returns to capture status after approximately one minute.
7
Press the shutter release button halfway.
The focus frame (or face recognition frame) on the display turns green
when the camera focuses on the subject at the correct distance.
8
Press the shutter release button fully.
After the message [Start interval shooting] appears, the display turns
off. When [Start Delay] is set to [0 min.], the display turns off after the
first image taken appears in Instant Review.
When the number of images set in [Number of Shots] is taken, the
message [Interval shooting complete] appears and the camera turns off.
• Interval shooting is not available in b (Auto Picture), X (Digital
Wide), S (Fireworks) or F (Digital Panorama) mode.
• The alarm will not ring during interval shooting.
• Refer to p.130 for instructions on interval shooting in C (Movie) and
V (Underwater Movie) modes.
• The display turns off between shots (during standby). Press the power
switch during standby to display the remaining number of shots and
interval on the display.
• The message [Stop interval shooting?] appears when the power
switch and then the 3 button are pressed during standby. To
cancel interval shooting, press the 4 button.
• Settings for interval shooting can also be made in [Interval Shoot] in
the [A Rec. Mode] menu. Perform Steps 4 to 6 to make the settings.
Interval Shoot
MENU
Interval 0 10min. sec.
Number of Shots
2
Start Delay hr. min.0
0
