A SERVICE OF

logo

C3412M (9/06) 19
Getting Started
Once installed, apply power to the Spectra IV/Spectra IV SE dome system. The system will start a configuration sequence.
When configuration is done, the following information is displayed:
Pelco Spectra IV/Spectra IV SE
Version X.XX
D Address: 1
P Address: 2
Comm 2400, N, 8, 1
CONFIGURE DONE
This information will remain on the monitor until dome operation begins.
Refer to the following pages to learn how to operate and program your dome system.
NOTE:
When installing a Spectra IV dome drive in a Spectra III
back box for the first time, a rebooting message will
occur. When the dome finishes rebooting, it will continue with a normal configuration sequence.