P/N: 4809654
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
29JUL05 v2.0 05MusGT(4809654v2.0)
1-1
A. Loosen the hose clamp at the throttle body.
Disconnect the plastic 3/8" tube assembly
attached to the passenger’s side valve cover.
Remove the plastic 3/8" x 90° connector from
the plastic tube that was connected at the pas-
senger’s side valve cover. Set this connector
aside to be re-used in a later step. Discard the
remainder of the hose assembly, as it will not
be re-used. (See Fig. 1-a.)
*** NOTE ***
The preferred method of removing the 90° con-
nector from its original plastic tube is to apply a
small amount of heat to the tube and slide the
connector free.
B. Disconnect the mass air flow (MAF) sensor
plug and remove the inlet duct and upper air fil-
ter cover from the car. (See Figs. 1-a, 1-b, 1-c.)
1. PREPARATION/REMOVAL
Fig. 1-b
Fig. 1-c
MAF CONNECTOR
RETAIN THIS END
Fig. 1-a
CRANKCASE
BREATHER HOSE
RETAIN
THIS END
Fig. 1-d
10mm HEADED BOLT
THROTTLE
BODY CLAMP
Section 1
PREPARATION/REMOVAL
Fig. 1-e
NYLON CLIPS
C. Remove the 10mm headed bolt that is located
next to the inner fender which secures the lower
portion of the air filter enclosure. Remove the
lower portion from the car-it will not be reused.
(See Fig. 1-d.)
D. Remove the six plastic push pins securing the
radiator cover. Remove the cover and set aside
to be reinstalled later. (See Fig. 1-e.)