P/N: 4809654
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
29JUL05 v2.0 05MusGT(4809654v2.0)
2-1
Section 2
OIL FEED INSTALLATION
A. Locate the factory oil sensor on the driver’s
side of the vehicle near the oil filter.
B. Remove the sending unit and set aside.
C. Locate the supplied 1/4"NPT street TEE fitting.
Install the TEE in the same location as the fac-
tory sending unit with the 1/4" x –4 x 90°
installed in the TEE at the location noted. (See
Fig. 2-a.)
D. Attach the stainless steel –4 hose to the –4 fit-
ting installed in the street TEE. (See Fig. 2-a.)
E. Route the hose away from hot, sharp or moving
parts and to the top of the engine to be attached
to the supercharger oil feed.
*** NOTE ***
The oil feed hose to the S/C will be installed in a
later step of the installation. Temporarily cap the
open end of the hose to prevent contamination to
the inside of the hose.
F. Reinstall the factory sensor in the branch of the
TEE as shown. (See Fig. 2-a.)
2. OIL FEED INSTALLATION
Fig. 2-a
FACTORY
PRESSURE
SENSOR
1/4"NPT x
-4 90°
