D. Install 90º fittings into the CAC so that they
point towards the front of the vehicle. One
of these fittings needs to be the supplied
“short” fittings in order to allow it to be
installed without hitting the other fitting.
(See Fig. 2-c)
E. Attach to tubes using 2 3/4" sleeve and #44
clamps.
F. Close hood and verify CAC clearance. If
interference occurs, loosen clamps and lower
CAC as needed.
2
A. Cut the original supercharger discharge tube
so that a 12 inch section of straight tubing
(with the bypass valve bung) remains (See
Fig. 2-a).
B. Cut 2 ¼” off of the straight section of the
carburetor enclosure inlet elbow. (See Fig.
2-b). De-bur and clean both ducts.
C. Re-install both ducts and use the supplied
sleeve to connect the discharge duct to the
charge air cooler (CAC) inlet. Tighten hose
clamps on all sleeves.
Fig. 2-b
Fig. 2-c
Section 2
Charge Air Cooler Install
2. Charge Air Cooler Install
Fig. 2-a
