8 51-3849, 5/26/06
Service & Repair - General
CAUTION - Do not modify the sweeper in any way.
Personal injury could result. If you have
questions, contact your dealer or
SWEEPSTER.
Repair or adjust the sweeper in a safe area, away from
traffic and other hazards.
Before adjusting or servicing - lower the sweeper to the
ground, set parking brake, shut down the prime mover
and remove the key from the ignition.
When working on or around the sweeper, safely secure it
from falling or shifting.
Service & Repair - Hydraulic Safety
Stop the prime mover engine and release hydraulic pressure
before servicing or adjusting sweeper hydraulic systems.
WARNING - Escaping hydraulic fluid can have
enough pressure to penetrate the skin,
causing serious personal injury.
Do not bend high pressure lines. Do not strike high pressure
lines, Do not install bent lines, bent tubes, or kinked hoses.
Do not install damaged lines, damaged tubes, or damaged
hoses.
Repair loose lines, loose tubes, and loose hoses. Repair
damaged lines, damaged tubes, and damaged hoses.
Leaks can cause fires. See your SWEEPSTER dealer for
repair or replacement parts.
Replace the parts if any of the following conditions are
present:
•The end fittings are damaged or leaking.
•The outer covering is chafed or cut.
•The reinforcing wire layer is exposed.
•The outer covering is ballooning locally.
•The hose is kinked or crushed.
•The armoring embedded in the outer cover.
•The hoses have been pulled or stretched.
Make sure that all clamps, guards, and shields are installed
correctly.
SAFETY SECTION
GENERAL SAFETY INFORMATION
Check lines, tubes and hoses carefully. Do not use your
hand to check for leaks. Use a board or cardboard to check
for leaks. Tighten all connections to the recommended
torque. See Appendix.
