51-3849, 5/26/06 19
INSTALLATION SECTION
RLH/RLCH
Brush Head Assembly
1. Position the brush head assembly behind the swing
assembly.
2. Align holes in the brush frame and swing assembly.
Install 3 carriage bolts, flat washers, lock washers and
nuts. Do not tighten the hardware; it must remain loose to
level the brush head assembly.
3. Assemble the spring-chain assembly/assemblies. Attach
the spring end(s) to the brush head upright. Then place
the chains in the slots on the swing assembly upright.
4. Connect the transport chain, which is attached to brush
head upright, to the remaining slot on the swing
assembly upright.
NOTE - Use the transport chain to take weight off the spring-
chain assembly/assemblies while transporting unit
between job sites.
5. Connect pressure and return hoses to prime mover
remotes.
NOTE - If 12 gpm (45.4 lpm) is not available, purchase a
power pack from SWEEPSTER.
6. Attach the pressure hose to the rear tube on the brush
head and the return hose to the front tube. The
Angle Feature
Manual Angle Kit
NOTE - Some sweepers use hydraulic swing instead of
manual angle kit. See Swing Cylinder later in this
section or Option - Hydraulic Swing/Electric Valve at
the back of this manual.
1. Slide the inner link into the outer link (figure 10).
2. Place link ends on swing assembly pins (figure 11).
Secure with cotter pins.
3. Position the brush head assembly at the desired angle.
Align holes in both links and install lock pin to keep the
brush head assembly in position (figure 12).
Figure 10
Figure 11
Figure 12
