22
R7 English
Product Description : Automatic Blood Pressure Monitor
Model : R7 (HEM-637-E2 / HEM-637-E7)
Display : Dot matrix LCDdisplay
Measurement : Oscillometric method
Measurement Range : Pressure; 0 to 299 mmHg, Pulse rate; 40 to 180 /min.
Accuracy : Pressure; within +/-3 mmHg, Pulse rate; within +/-5% of
reading
Inflation : Automatic inflation with pump
Deflation : Automatic rapid deflation
Power supply : Two LR03 alkaline batteries (AAA)
Battery Life : Approximately 300 times of measurement when using alkaline
batteries (In case of the monitor is used three times a day
inflating to 170 mmHg at the room temperature of 22°C)
Operating Temperature
and Humidity : +10° to +40°C, 30 to 85% RH
Storage temperature
and humidity : -20° to +60°C, 10 to 95% RH
Measurable
circumference of wrist : 135 to 215 mm
Weight of Main Unit : Approximately 150 g (not including batteries)
External Dimensions : 78 (W) x 65.5 (H) x 37.2 (D) mm (not including the wrist cuff)
Electric Shock Protection : Internal power supply appliance type B
Accessories : Two LR03 alkaline batteries for monitoring use, storage case.
Instruction Manual, blood pressure pass, guarantee card.
• In the interest of product improvement, specifications are subject to change without notice.
Manufacturer OMRON HEALTHCARE Co., Ltd.
24, Yamanouchi Yamanoshita-cho, Ukyo-ku, Kyoto, 615-0084 JAPAN
EU-Representative: OMRON HEALTHCARE EUROPE B.V.
Kruisweg 577, 2132 NAHoofddorp, THE NETHERLANDS
Made in China
This device fulfils the provisions of the EC directive 93/42/EEC (Medical Device Directive). This
blood pressure monitor is designed according to the European standard EN1060, Non-invasive
sphygmomanometers Part 1: General Requirements and Part 3: Supplementary requirements
for electromechanical blood pressure measuring systems.
This OMRON product is produced under the strict quality system of OMRON HEALTHCARE
Co., Ltd., Japan. The Core component for OMRON blood pressure monitors, which is the
Pressure Sensor, is produced in Japan.
=Type B
Spare parts and accessories
OMRON considers, due to the used high company and quality standards, the main unit as a
non-serviceable part because of the necessity of proper calibration after replacement of high-
tech components.
The cuff can be replaced by an authorised expert.
Specifications
HEM-637-E2 EN 7/8/10 9:18 AM Page 22
