Handbook
|
33
Tone/Pulse (MF/DP)
Speed access no. 45
This function controls which method your machine uses for
dialing: DP, dial pulse dialing which uses monotone pulses to
dial a number like a rotary telephone, MF, multi-frequency
dialing (touch tone) which uses different tones to dial a
number. MF is the default setting.
Tone (MF) Duration
Speed access no.49
If the machine is set to the MF dialing method, this function
controls the duration of the tones used for dialing (Tone
duration varies by country). Available settings are 75, 85, and
100 ms.
PBX LINE
Speed access no. 50
Turn this function on if your machine is connected to a PBX.
Once this function has been turned on and the access digit
function has been programmed, your machine will recognize
the access digit you use in your PBX to get an outside line.
After it dials your access digit, your machine will pause to
wait for an outside line before dialing the rest of the
telephone number. Available settings are on and OFF. See
"Connecting to a PBX" in the Installation chapter for
instructions to change this setting.
FLASH/EARTH/NORMAL
Speed access no. 51
If your machine is connected to a PBX, this function tells
your machine about the type of PBX line your machine if
connected to. Available settings are NORMAL (N), flash (F)
and earth (E).
DIAL PREFIX
Speed access no. 52
If your machine is connected to a PBX, use this function to
tell your machine what access number is used to obtain an
outside line from your PBX. You can enter up to 4 digits. See
Connecting to a PBX in this chapter for instructions on
changing this setting. Available settings are on
and OFF.
