A SERVICE OF

logo

NetComm 16 or 24 port Gigabit Switch YML711 Rev1
32 www.netcomm.com.au
Set Password
The Set Password screen allows the network manager to secure the Switch settings. Use this screen
to change the password.
If you forget the password, you can press the “Reset” button in the rear panel of the Switch to
restore the Switch to its factory default settings.
Note: All other settings will also be lost, including VLAN, Port Settings, etc. Refer
to Backup Setting to back up your settings before restoring the Switch to its
factory default.
Figure 27. Set Password