Chapter 1 Introduction
NI 5102 User Manual 1-6 ni.com
PXI-specific features, RTSI bus trigger, RTSI Clock, and Serial
Communication are implemented on the J2 connector of the CompactPCI
bus. Table 1-1 lists the J2 pins used by your NI 5102 (PXI) digitizer, which
is compatible with any CompactPCI chassis with a sub-bus that does not
drive these lines. Even if the sub-bus is capable of driving these lines, the
NI 5102 (PXI) is still compatible as long as those pins on the sub-bus are
disabled by default and are never enabled. Damage can result if these lines
aredrivenbythesub-bus.
Optional Equipment
NI offers a variety of products to use with your digitizer, including probes,
cables, and other accessories, as follows:
• Cables for master/slave timing and triggering
• Cables for external triggering
• RTSI bus cables for NI 1502 (PCI, ISA)
• AUX Interface Cables for NI 5102 (PXI) only
For more specific information about these products, refer to the NI catalog
or website, or call the office nearest you.
Table 1-1. NI 5102 (PXI) J2 Pin Assignment
NI 5102 (PXI)
Signal
PXI Pin Name PXI J2 Pin Number
RTSI Trigger <0..5> PXI Trigger <0..5> B16, A16, A17, A18,
B18, C18
RTSI Trigger 6 PXI Star D17
RTSI Clock PXI Trigger (7) E16
Serial
Communication
LBR (6, 7, 8, 9, 10,
11, 12)
EI5, A3, C3, D3, E3,
A2, B2
