13
▶ Using the focusing knob,
displace the collector:
• Duringthismovement,the
collector must not touch
the flexible power cable. If
necessary, bend the cable
away
▶ Carefully close the lamp housing, making sure that
the dis connect plug engages the socket
▶ Press in the disconnect plug slightly
▶ Tighten the screws
▶ Push the disconnect plug fully in to the stop
without turning it.
Lamp housing assemble
▶ Using the Allen key, release
the hollow screw
▶ Introduce the lamp housing
into the adapter of the
fluo res cence module and
tighten the hollow screw.
Stray-light protection
There are slots in the lamp housing through which UV light can
shine on the user's hands during manipulations beneath the
housing. The stray-light protection on the underside of the lamp
housing is designed to block this light.
▶ Secure the stray-light
protection with two screws.
Removing the collector and the heat-protection filter
The collector and the heat-protection filter can be removed
for cleaning or if defective.
▶ Open the lamp housing as described on page 12 and remove
the burner socket
▶ Move the reflector fully to
the right-hand stop
▶ Holdthecollectorandpull
out the focusing knob
▶ Extract the collector
▶ Slacken the two screws
and remove the heat-
protection filter from the
collector
▶ Screw a new heat-
pro tection filter into
position
Replacing the collector
▶ Pull out the focusing knob
▶ Carefully replace the collector and move it to the left until
the focusing knob engages the guide groove
▶ Test the displacement of the collector
▶ Refit the burner socket (page 12) and close the lamp housing.
