8-6 ENGINE REMO VAL /INSTALLATION
Engine Removal/Installation
•
Remove:
Radiator Hose Clamp [A] (Loosen)
Radiat
or Hose [B]
Oil Cooler Water Hose Clamp [C] (Loosen)
Oil Cooler Water Hose [D]
Radiato
r Bolt [E] (Loosen)
Radiator Bracket Bolt [F]
•
Disconnect
Crankshaft Sensor Lead C onnector (see Electrical Sys-
tem chapter)
Stick Coil Harness Connector [A]
•
Remove:
Air Cleaner Housing Bolt [A]
•
Loosen:
Throttle Body Assy Clamps Bolts #3, 4 [B] (see Fuel Sys-
tem (DFI) chapter)
Special Tool - Ca rburetor Drain Plug Wrench, Hex3:
57001–1269
•
Remove:
Left Radiator Cover [A] (see Cooling System chapter)
Left Frame Cover [ B] (see Frame chapter)
Shift Lever [C] (see Crankshaft/Transmission chapter)
Engine Sprocket Cover [D] (see Final Drive chapter)
Radiator Hose Clamp [E] (Loosen)
Radiator Hose [F]
•
Pull off the connectors from the engine and free the wiring
from the clamps.
○
For California M odel, remove the separate.
Starter Motor Lead [A] (see Electrical System chapter)
Alternator Lead Connector [B]
Neutral Switch Lead Connector [C]
Side Stand Switch Lead C onnector [D]
•
Remove:
Engine Sprocket (see Final Drive chapter) [E]
